shroud height 3d models
325704 3d models found related to shroud height.thingiverse
This is a modified version of vdwel's one, this gave me the best results possible with my Anycubic Kossel Linear Plus. ... It has even less height, identical arms (both long) and back hole removed. ... Enjoy.
thingiverse
Adjustable height cooling fan shroud for the adjustable Prometheus V2. I have not tried all the the different heights settings as it would take a lot more time. I am using it with 2 nuts under the heat block, one nut above and 2 mm transition zone. I...
thingiverse
This is a remix of the Hot!2 fan shroud, pick the one you need ! ... Designed using [OnShape](https://cad.onshape.com/documents/873a51657f8fb803db2ff796/w/8c526b52ee049e223c7bc3a8/e/a38e66e5db4b169b8944cfd2)
thingiverse
This is a modified version of the "AnyCubic Delta Vortex Fan Shroud For PLA V3" by grandysims (https://www.thingiverse.com/grandysims) With slightly higher offsets so that the fan output gets closer to the nozzle. ... Original design: ...
cults3d
Sidewinder shroud support for BLTouch at a usable height. Had to remix a model where after installation the retracted probe was still 1cm under the extruder, event without the springs. This mount is a bit reinforced and designed to be used with the...
thingiverse
Sidewinder shroud support for BLTouch at a usable height. Had to remix a model where after installation the retracted probe was still 1cm under the extruder, event without the springs. This mount is a bit reinforced and designed to be used with...
thingiverse
MK8 i3 - 50mm Radial Direct Fan Shroud Geeetech with height adjustment
thingiverse
MinV2 Ender 3 fan Mount is one of my favourite fan mount and I use on all my Ender 3 Pro and 5 Plus but there was the need of a bracket for the Mini Differential Height Sensor for my two Ender 3 Pro equipped with Duet2 wifi, so I designed this one.
thingiverse
Slight Remix to make it height Adjustable. I used it on my Adimlab Gantry with an E3D v6 hotend. ... Tinkercad link: https://www.tinkercad.com/things/7dTHienanYc
sketchfab
Shroud is a sculpture I created for the Sketchfab VR Sculpture Park Challenge. While I created it with specific experiences from my life in mind, its interpretation is ultimately up to the viewer. ...I hope you enjoy.
thingiverse
A shroud with print cooling fan duct " 40 mm fan", its a fragile little thing but printed fine with 18% infill, 3 perimeter "1.2 in cura" and .3 layer height.