sinter rod 3d models
64742 3d models found related to sinter rod.
thingiverse
I did a remix of that to carry my sinter bearings. ... Thanks for the original :)
thingiverse
... I always wanted to try sintered bearing bushes on the X- and Y-axis, preferably on 12mm shafts. So I started a test, but first on the old 8mm shafts. Therefore I developed the carriers shown here with OpenSCAD, very simple, without much effort.
thingiverse
This thing was made with Tinkercad. ...Edit it online https://www.tinkercad.com/things/9tRhW2Y6NMF
thingiverse
This thing was made with Tinkercad. ...Edit it online https://www.tinkercad.com/things/9tRhW2Y6NMF
thingiverse
It can be used as a direct replacement when converting from 8mm rods + LM8UU to 12mm rods and 12x15x10mm sinter bearings. *Note: i revised these blocks as they wore out after about 6 months. My sinter bushing had a bit of play inside the old...
cults3d
Features: 2 point mount for better alignment a fixing screw (standard M3x12 from the kit) that it can't wobble oder make noises perfect fit for sinter bronze bushing with the dimensions 8x10x15 (can be found here:...
thingiverse
Features: 2 point mount for better alignment a fixing screw (standard M3x12 from the kit) that it can't wobble oder make noises perfect fit for sinter bronze bushing with the dimensions 8x10x15 (can be found here:...
grabcad
The flue gases after sintering tapes for metallurgical production are scrubbed of gas scrubbing apparatus in water mist. After a lifetime of equipment repair, or upgrade, or dismantled and then replace the electrostatic precipitators. Дымовые газы...