socket pegboard 3d models
49359 3d models found related to socket pegboard.
thingiverse
Pegboard holder, which fits on European style pegboard (in my case the pegboard from Hornbach (Germany))
prusaprinters
I really liked the model JohnnyDawg made available ( https://www.printables.com/model/198774-kupper-pegboard-21x-screwdriver-holder), but the pegboard pattern used for this tool holder was keyhole pegboard versus the standard pegboard pattern on my...
thingiverse
I'm confident that these Pegboard mounting brackets will work with numerous tool types designed to complement the Sealey Metal pegboard solution: https://www.sealey.co.uk/product/5637184563/steel-pegboard-pack-of-2. However, I suspect that these...
thingiverse
... and I didn't have a convenient spot to put it without obstructing my view. ...A pegboard sat nearby, and my phone had a pop socket attached, which sparked an idea. I'm considerate and decided not to add a watermark. ...That's all there is to say.
thingiverse
I remixed the original design (meant for the new 9/32 pegboard) using pegs generated by https://www.thingiverse.com/thing:537516 I used a 3/8 inch aluminum rod, which is a snug fit Included a test piece to make sure the spacing and hole sizes match....
prusaprinters
I have old pegboard in my garage, where the holes are only 3/16 inch diameter, and the board is 4mm thick. I remixed the original design (meant for the new 9/32 pegboard) using pegs generated by https://www.thingiverse.com/thing:537516 I used a 3/8...
thingiverse
... were made to suit slightly smaller openings. ...Following printouts, I observed that the lower hooks' vertical dimensions were too big to fit onto my pegboard. ...The bevel on top of each lower hook was carefully removed, resulting in a perfect fit.
thingiverse
This is a ground-up redesign of GA_3D's design, tailored specifically for 1/8 inch thickness pegboard, which can be found here: http://www.thingiverse.com/thing:559094. The original design I printed from PLA, and even though it was too short,...
thingiverse
I designed a pegboard shelf to accommodate my tape measure perfectly - after printing it out, I noticed an abundance of excess material in the model that I could improve upon - I've since created a second iteration called tapeholderthin, which...