sparkfun gps 3d models
9546 3d models found related to sparkfun gps.
thingiverse
A simple yet effective GPS mount (Matek GPS) is designed specifically for the ImpulseRc Alien frame. The latest Version 2 has a minor raised section in the center to prevent stress on the connector, which can cause disconnection of the GPS signal.
prusaprinters
Use a drop of hot glue over the pegs to make a more durable project. This design can mount two of the two hole variety with two of the four hole models or up to four of the four hole modules. Print instructionsCategory: Electronics Summary An 8020...
thingiverse
Here's a rewritten version of the text: Install GPS antenna kit on Renault Laguna, I assume it will work with other models too.
grabcad
The Ublox 6M GPS module offers high-precision positioning for your remote control quadcopter, featuring a compass GPS antenna for enhanced accuracy. ...This advanced technology ensures smooth flight and precise navigation, making it an essential...
thingiverse
A Simple Case for the SparkFun ESP32 LoRaWAN Single Channel Gateway Protecting the connector is a must. It's a straightforward project. This gateway features a compact OLED screen that utilizes the QWIIC connector. The screen's printed circuit board...
prusaprinters
You will need to print a retaining tabs, which can be found at: https://www.thingiverse.com/thing:3401942 or https://www.prusaprinters.org/prints/8512-din-rail-mounting-tab An Din Rail mount for up to four Sparkfun Qwiic modules using M3 screws. This...
cults3d
Designed for FPVCYCLE CINEGLIDE 7" FRAME For the compass to work properly you have to adjust the angle in INAV.inav/wiki/GPS--and-Compass-setupPainless360 - How to setup a compass in INAV when it is at an angle? This gps mount is tilted Backwards...
thingiverse
[inav/wiki/GPS--and-Compass-setup](https://github.com/iNavFlight/inav/wiki/GPS--and-Compass-setup) [Painless360 - How to setup a compass in INAV when it is at an angle?](https://www.youtube.com/watch?v=tjKPD69Lrgg) This gps mount is tilted Backwards...
prusaprinters
The SparkFun Robotics Claw MkII (part # ROB-11524) is a big improvement on their mark 1 model. The new Pan/Tilt MKII bracket (part # ROB-11674) is also nice (if a tad pricey). Unfortunately the instructions to mount a claw to the Pan/Tilt bracket...
thingiverse
I mounted the NZ GPS on a homemade bracket made from a 3mm wooden stick. The setup looks sleek and professional, giving me confidence in its stability and accuracy. ...If you're looking for a more portable option, I recommend checking out this foldable...
thingiverse
This is a support I made for the Tractive GPS that my dog carries, since buying it again cost me € 15 with transport. The original broke down so I replaced it with this one. It is a different design than the original but it works. I wish it would be...