sparkfun rfid 3d models
1958 3d models found related to sparkfun rfid.grabcad
Sparkfun RFID Breakout board 13030 and RFID Reader ID-12LA. ...SolidWorks 2016.
thingiverse
Hello! ...This is just a simple case for the sparkfun rfid starter kit designed to be mounted under your desk or wherever you want to hide it.
prusaprinters
This is an enclosure for the Sparkfun's RFID USB Reader (SEN-09963).
thingiverse
This is an enclosure for the Sparkfun's RFID USB Reader (SEN-09963).
prusaprinters
This thing contains a mounting plate and a drilling guide for the "SparkFun RFID USB Reader" (SEN-09963).The base plate is one mm thick. M2 5 mm or 1/4" 4-40 screws are needed to fasten the board to the mounting plate. The mounting holes are three mm...
thingiverse
This thing contains a mounting plate and a drilling guide for the "SparkFun RFID USB Reader" (SEN-09963). The base plate is one mm thick. M2 5 mm or 1/4" 4-40 screws are needed to fasten the board to the mounting plate. The mounting holes are...
grabcad
"The SparkFun Simultaneous RFID Reader is an Arduino-compatible board to get you started with the M6E Nano UHF RFID Reader. Radio Frequency Identification (RFID) is becoming popular everywhere for tracking practically everything. ...Whether you want to...
prusaprinters
Box designed for outdoor assembly of sparkfun qwiik KIT-15209 rfid reader.Printed and assembled.I have tried to design this so water that enters the box should not reach the circuit board.Cable is to be pulled thru wall from inside of box.Not tested...
thingiverse
You would need to use two spacer shields with Misty for this mount design to work. ... Link to the SparkFun Shield : https://www.sparkfun.com/products/14066
thingiverse
Customized version of http://www.thingiverse.com/thing:155001 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=155001 Instructions Using the following options:...
thingiverse
Customized version of http://www.thingiverse.com/thing:155001 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=155001 Instructions Using the following options:...
thingiverse
This is a RFID keyfob for a .91 inch by .04 inch round RFID chip. ...Not sure if fitment will be perfect, but lmk if its not.