spiderman controller holder 3d models

<p>Print in PLA&nbsp;</p><p>0.2/0.3mm layer height&nbsp;</p><p>No support needed&nbsp;</p><p>2x CHC M4x10 screw</p><p>2x T-Nuts M4</p>

One of my first designs, let me know if you have any suggestions on how to better it.

Designed this for nintendo switch but obviously can be used for other consoles as well.

Free filament is available at 41 Locust Lane in Northport, New York 11768.

<p>Internal dimensions 2.5" wide x 0.75" length x 2" deep. ...I used a 3M strip to adhere it to the bottom on my desk.&nbsp;</p><p>Print on it's side, some overhangs will cause some stringing that can be cut away or melted in place post print.</p>

Use tape or stickers to mount it on the edge of a surface

Edit the dimensions to 64 by X, 83.74 by Y, and 48.48 by Z. ...I hope this revised design meets your expectations.

This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/1jCTYYf8hqC

<p>Printed without brim standing on a satin sheet in PLA. ...I printed it with a 0.6 nozzle, but I see no reason why a 0.4 nozzle shouldnt also work.</p>

This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/1jCTYYf8hqC

support for my super Nes console that I make available for all fans on the subject.

I designed this to hang over the lip of my bookshelf, but it can be hung over anything with a lip on it.

This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/1jCTYYf8hqC

Adjusted a bit. Base was rotated for cleaner printing and the screw holes were moved up for a better load spreading. ...Arms were adjusted to fit completely into the base and added a small bit for the front that spreads the weight better and also makes...

I finally caught on after printing the original out of whack - just a simple flip did the trick! ...Big shoutout to xlsergval for figuring this one out long before me.

the original creator is unknow but secondary source is: https://www.thingiverse.com/thing:4051648 I have made this so it is compatible with two screw points so it will be more secure. there are who files... one with holes 24 mm apart and the...

I created a base that I needed, so I modified Webberen's to fit my requirements, and here it is if it works for someone else. It is designed to be screwed from under a shelf or desk. I drilled two holes for screws. Works great thanks to Webberen.

This small original handle rest is very convenient, allows you to store your joystick easily, here is a short video of 7seconds as a demo: https://youtu.be/czYdrTUBBf0 3D Print Settings : I advise you to use media when printing to improve the...

The DJI Mavic Air drone: The charging base often has loose connections that need securing. This is an easy DIY fix. ...3D prints in approximately seven minutes at twenty-five percent volume settings.

This is a Version with xbox Logo

very easy print Message me if you have any questions. ...:)

I've upgraded to an HTC tracker, rendering my simple mount for my motion simulator obsolete.

will publish the finished prints soon, you might need to resize to 10%

With tinkercad's incredible features, you're free to customize and fine-tune this project however you see fit - just download and start modifying away!