spinner top toy 3d models
318143 3d models found related to spinner top toy.prusaprinters
Have you ever wanted a spinning top that spun while also having a part of it spin itself?? Confused? ...Just print this and you will see what I mean!</p>
thingiverse
This is based on a toy that my son has for his granddaughter. ...I used that as inspiration and designed my own. The top screws on and off so additional spinners can be added. The top can then be glued on if desired. ...
grabcad
It's simple design of a toy named Spinner. ...In the File you will get Two parts and their assembled part file.
pinshape
Here is a easy to print spinner toy for small children. Use superglue to secure the sticks to the base. Parental supervision is required. ...Discard any broken toys, as the small pieces could be sharp, or pose a choking hazard.
thingiverse
Made as a replacement spinner for kid's game, but good for any spinning needs. ...The top is superglued to the post!
thingiverse
This toy was quickly approved by my daughter, motivating me to post it to Thingiverse. The wings are very loosely attached which seems to help with the spinning. ... Instructions Upper body > plastic...
thingiverse
This top was designed after designing and making some roller-nearing spinner toys for my daughter. This top is the next thing. Tops that wobble and turn about 20 times and fall are no fun. Correct me if I'm mistaken but the key to a long-spinning...
cults3d
... Mark spinner top Creates the visual effect of the " ! " Exclamation Mark when spun on the bottom. Also spin able upside-down too! Scaled at 7cm Diameter and 4.4cm Tall I declare Spinning Top is the original Fidget Spinner, CHANGE MY MIND lol :D
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=417803 Instructions Using the following options: WALL_THICK = 1.6 DRAWER_DEPTH = 150 DRAWER_WIDTH = 200 MESSAGE = Top Spinner FLOOR_THICK = 1.2 DRAWER_CORNER_RAD = 2 CLEARANCE = 0.5...
thingiverse
Yet another spinner top which comes in 3 parts needing some assembly and glueing. It performs quite well, even if printed light. I used 20% infill which results in a relatively low mass but it was still fine and fun to play with. Print Settings...
thingiverse
This is just a table top spinner for fun Contact me at Pjenkins257@gmail.com if you have any questions
thingiverse
Toy Top. ... Instructions This model will need to be built using support, as the model will probable not lay flat on the build tray.
thingiverse
What can I say? ...It is a toy top. We had a contest to make a simple part to be put on the backend software for one of our printers. ...I did not win, but I think it turned out fine.
cults3d
A spinning top for testing printing without support - it was printable on the m3d printer without problems.