spyderco pm2 backspacer 3d models
396 3d models found related to spyderco pm2 backspacer.thingiverse
This is a simple snap-in backspacer for the Spyderco Smock model. ...It goes around the original barrel spacers and can be removed by just lifting up and under the tail of the spacer.
thingiverse
... look good. No supports needed. There is a angled ramp so it will not hit the compression lock. Added a Spyderco logo, but you don't see it when installed. ... To install: Must remove one back spacer (two screwsT8) Hooks around the lanyard hole
thingiverse
This is an accessory for the Spyderco Paramilitary 2 folding knife, designed to fit into the opening hole on the blade and function as a wave opener. It is easy to install and remove without any tools or additional parts. ...It could be modified to fit...
thingiverse
Here I give you my Para 2 Backspacer parts so you can print yourself some too. You can separate the different parts in your slicer. So you don' t need to print them all at the same time :) Have fun and keep printin! It took quite a...
thingiverse
Here I give you my Para 3 Backspacer parts so you can print yourself some too. You can separate the different parts in your slicer. So you don' t need to print them all at the same time :) Have fun and keep printin! It took quite a...
thingiverse
I used HavardJensen's PM2 backspacer and modified it so you don't have to take the knife apart to put it in. You loop the hook around the lanyard hole and squeeze in until the other hole pops in. Thanks for the great model! Mine is in glow in the...
thingiverse
Remixed to have a textured pattern along the entire back of the part. ... Part still swings in and snaps without tool.
cults3d
The Para3+ is simply designed to provide the feeling of a pm2 handle in a Spyderco para 3, whether for ergonomics or simply to test what a pm2 might feel like. (See the pm2 scale comparison in the picture) I made it in both a solid and skeletonized...
cults3d
... to press into the round holes on Spyderco knives. ...They provide a "pocket-opening" effect when the knife is drawn while the blade is positioned tip-up, with the spine towards the rear of the pant pocket. This one is for the Spyderco Pm2 and Para3
cults3d
Holster made for ICS PM2. ...made to attach in a universal platform To assembly the project you will need ->10 threed brass incerts, metric 2,5mm for plastic ->10 screws M2.5 x 5mm ->A spring 8 x 15mm with 0.8 wire.
thingiverse
Backspacer for Benchmade 535 Bugout knife One is Smooth The other has grooves in it.
thingiverse
this is a replacement backspacer for the Kershaw OSO Sweet. ...you will need to disassemble the unit to install.
thingiverse
This is a replacement backspacer for the kershaw Link. ...you will need to disassemble to install this.
thingiverse
This is a snap in place backspacer for the Kershaw Grinder. ...The fit is a little snug in the middle.
thingiverse
This is a snap in place backspacer for the Kershaw Shield. ...It can be installed without disassembling the knife
thingiverse
This is a snap in backspacer for the Kershaw Cryo. ...It can be installed without disassembling the knife.