square key cover 3d models

After changing the UPVC door locks I had the problem of finding out the the supplier couldn't supply matched barrels, which meant I had three identical keys to carry around. ...So I designed a colour identification sleeve for each key to solve the...

Use TPU in this design, one side is bigger then the other so you can just slip it in note: i didnt use support on mine since i know it was going to be a pain to remove, so my advice is to do the same, and ass some extra fans when you do that over...

This is a key-cap/cover for a square-hed (~28.4mmx28.7mm) key.

This is a key-cap/cover for a square-hed (~28.4mmx28.7mm) key.

This is just a square key.

Simple Square Key based off of a reference image

wrench for 10mmx15mm square spigot

... mit 4-5 aussenschichten und 30% infill. 7,8x7,8mm; 8,4x8,4mm; 8,7x8,7mm I designed this square key in 3 different sizes. With name of my Dad. ... I printed in PLA without support with 4-5 outlines and 30% infill 7,8x7,8mm; 8,4x8,4mm; 8,7x8,7mm

Square cover

Square drive for the activation of small mechanisms.

Works on 4mm squares. Print at 0,1mm with 100% fill. ...Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2...

square bits sizes are:4.8 (5mm hole)5.8 (6mm hole)6.8 (7mm hole)I've printed it using Prusament ASA, 0.2mm layer height, 50% infill 

10mm parameterizable square key

Small 8x8mm square key keychain

Simple T-Bar / Square Key

Square utility key for household radiators - 5mm

Square key ring with spherical insert

square key ring with cross insert

Its An Key for UIC-Square Locks.

Central heating square key to remove air from the system.

Keys for square bolt commonly found in gates, windows etc.

A key chain case to hold your square card reader.

Central heating square key to remove air from the system. ...

Key cover

Key Cover !

Key Cover !

cover key

Since the original square key for my inspection flaps broke in the basement, I thought about this better design myself.

A easy Key Cover.

I needed i nice square key for my garbage column door so I started from a basic recycle spinner, edited it to cobine it on a single object and created the 7.5mm key part I needed.