ssd trail king 3d models
21713 3d models found related to ssd trail king.thingiverse
Headers for the SSD Trail King V8 engine. This requires four 1.5mm screws to mount the headers to the block. I designed this for use with the 23mm engine spacer (from SSD) and cant confirm this will work in the stock location or with the 15mm...
thingiverse
http://www.rccrawler.com/forum/ssd-trail-king-pro-scale-chassis-builder-kit/611604-humboldtefs-lc70-ssd-trail-king.html This is intended for experienced builders and will require you to do some DIY work, dont expect me to change anything for you. ...
thingiverse
This radiator & shroud covers the servo on the SSD Trail King. The radiator has a groove in the top and bottom so that zip ties can be slid in place here to provide the radiator look. I used small zip ties that were 2.5mm wide by .9mm thick. This...
thingiverse
just a quick valve cover to replicate a big block. i printed with support . ...enjoy
thingiverse
This spacer move the engine 15mm forward and 6mm higher. ... The oil pan cant be used with this spacer.
thingiverse
This spacer moves the engine 23mm forward and 12mm higher. ... The oil pan cant be used with this spacer.
myminifactory
This is a body mount set for using the RC4WD K5 Blazer body or cab from a pickup conversion with the Axial SCX10ii and SSD Trail King chassis. The body tab is designed to allow four different positions to fine tune the body positioning to the...
thingiverse
These front body posts are for SSD Trail King Aluminum Wide Front Shock Hoops (SSD00355). ... These put the body mount back to the stock position.
cults3d
This will fit the SSD Trail King Pro KIT scale 1:10 crawler to add two servo mount options. This will allow having steering servo and a winch servo mounted, without any trimming or modifications to the KIT. ...Straight mount with KIT hardware and...
thingiverse
I broke my trailing arm in my Kyosho trail king so here is a printable replacement. ...print with supports.
thingiverse
This is a rack to hold two King Dian half-slim ssds in a standard 3.5 inch bay. Doesn't have side holes yet. Holds them at a slight angle because easier cables. ...Good for running cheap SSDs in raid.
cgtrader
product cinema 4d was created. high quality presentation is made. Its poly structure is smooth. It has a pattern with a knitted net. does not need to be softened. all parts are modeled separately. It can be replaced comfortably. color and texture can...
thingiverse
This rear body post allows a TRX4 Bronco body to be mounted to the Trail King and SCX10 II chassis.
thingiverse
... ...http://www.thingiverse.com/apps/customizer/run?thing_id=52734 Instructions Using the following options: Font = write/orbitron.dxf stick_width = 8 font_thickness = 5 stick_thickness = 3 message = SSD hole_radius = 3 flat_bottom = 2 font_size = 10
thingiverse
A improvement on the stock sproket, the chain and track sproket is now one piece for added duribility, the track sproket teeth are beefed up and slightly wider, and finally it is now bearing supported, this design will accept a two 6x12x4 bearing on...