starbucks stoppers 3d models
5461 3d models found related to starbucks stoppers.thingiverse
Starbucks cup stopper. ...Just thrown together for someone on a group who was struggling with a print.
thingiverse
The normal disposable stoppers are too small for the reusable Starbucks cup.
thingiverse
Designed to stop Starbucks drinks from spilling as they don't have the plug/stirrer that DD offers. Print at 125% scale. Printed vertically. Fits the opening snugly, be sure to wash before and after each usage. Printed in PETG .12. ...
cults3d
Designed to stop Starbucks drinks from spilling as they don't have the plug/stirrer that DD offers. Print at 125% scale. Printed vertically. Fits the opening snugly, be sure to wash before and after each usage. ...Printed in PETG .12.
thingiverse
Have one of those Starbucks Reserve cups without a sealed lid? Me too, so I designed a seal. There are designs included for a logo-free version and a version with a logo. ... Happy printing!
cults3d
Starbucks Reusable Hot Cup Coffee STOPPERS STL Pack - Seals into cup lid - Avoid spills - For 3D Printing - Digital Files Enjoy ten different unique Coffee Stopper STL Files! These are great to prevent spills. To legally sell any PRINTS of my...
thingiverse
for anyone that likes Starbucks K-Cup coffee I would use a raft for the filler Starbucks
thingiverse
For anyone that likes Starbucks coffee for the filler I would use a raft to keep the pieces in place
grabcad
... since the needs vary depending on the usage. Most chem stoppers use a 5 mm hole (#000, #00, #0 use a 3mm, and #1 uses a 4mm). ...Brewing supply shops usually have the stpppers drilled out with a 9mm to fit various air locks and other equipment.
thingiverse
I was tired of getting blinds to hang evenly, so I designed this very basic and simple blind stoppers to make the blinds hang level always with ease and without worrying about which thread to let go more etc...
thingiverse
Needed new stoppers in bathroom, tweaked this one for flexible tpu with Tinkercad for my drains. new dimentions bath 40:40:18, sink 38:38:20. Sink was a little tight, could probably go down to 37:37:19 but it's a good solid seal so I'm happy....
prusaprinters
Needed new stoppers in bathroom, tweaked this one for flexible tpu with Tinkercad for my drains. new dimentions bath 40:40:18, sink 38:38:20. Sink was a little tight, could probably go down to 37:37:19 but it's a good solid seal so I'm happy. Print...