switch stand 3d models
216863 3d models found related to switch stand.
thingiverse
Nintendo Switch Stand Print it in 3 parts so you have a multicolour stand
myminifactory
A switch stand that collapses for transport. Allows charging while in stand. ...Prints with minimal supports.
myminifactory
75 degree Nintendo Switch stand. Holds 8 games and 2 micro SD cards. ... Print sideways with support in the middle.
myminifactory
Nintendo Switch Stand Holds your Switch at a 60° angel. ... Simply slide the stand on your switch like a normal joy con
thingiverse
Nintendo Switch Stand with a HZD Hunter's pendant design. ...(I know, wrong platform but it looks cool!) Print on its side for best results.
thingiverse
a moving (optional) HO Scale Switch Stand. print at 0.1 or better. note: depending on your build plate the parts may be hard to remove. ...
thingiverse
Nintendo Switch Stand Portable ・Drill a hole with a drill of 1.8 mm to 2.0 mm ・Insert a 1.75 mm filament Print Settings
cults3d
Nintendo switch stand for the regular version of nintendo swtich and special editions( not nintendo switch lite) , Includes instructions Stand for nintendo switch, for the normal version and special versions (not for nintendo switch lite) includes...
thingiverse
A combination of a bulbasaur planter and nintendo switch stand. ...I originally made this for my friend's birthday, and wanted to upload the model once I confirmed it worked.
thingiverse
This nintendo switch stand holds the console at multiple angles. ... It also has a hole for the power cord as well as holes for the speakers in the back.
thingiverse
Nintendo Switch stand with game holder slot Check out my facebook page if you have time and give it a like.https://www.facebook.com/JNpixels-3D-print-1676185979268651/
thingiverse
This is a fairly compact and simplistic Nintendo Switch stand design. With measurements being 196x 51.4x 45 mm (7.5x 2x 1.75 in), it can be carried fairly easy. Any feedback is appreciated. ...*-^
thingiverse
75 degree Nintendo Switch stand. I used the basic model from Ospi and remodeled it to hold 8 games and 2 micro SD cards while leaving enough room for a charging cable. ...I recommend printing it sideways with support in the middle gap.
youmagine
stable fit for the Nintendo Switch (two pins that fit in the holes at the bottom of your Switch) perfect angle for table mode (unlike the build in kickstand) good airflow - vent slots are free (no overheating) USB-C port accessable low material costs...
thingiverse
This is a modification of [Nintendo Switch Stand by titusou](https://www.thingiverse.com/thing:2228928). Using Netfabb, it has been split in half vertically with pegs added to connect each half. With this modification the stand can be printed without...