tech deck handboard trucks 3d models

They may not look the best, but they should work. you need to find some screws that fit, each hole is 1 mm in diameter, except for the part where the rubber goes. do a temperature of 190 Celsius - 205 celsius. ...I hope it works good, (and I'm not sure...

tech deck

tech deck ramp

Low cost Tech Deck ramp!

tech deck ramp used pla

Just a fishtail tech deck

A little Ramp for a Tech Deck

little tech deck duded i made

Great tech deck ramp equipped with stairs!

Have fun with a tech deck ramp

designed this euro style bench/ledge for tech deck fingerboards. ...

This is a model of a Tech Deck feature that I made. ...It resembles a skatepark!

this is a box for your tech deck. ...So make sure you have fun

pro hand skate

Occupational Therapist asked me to design this for use with his outpatient clinic. ... I would suggest gently sanding the corners.

You know how you've always wanted a tech deck? ...Yeah me too! well now you can just print it! Its a really cool tech deck but there is a little trouble with the wheels turning.

A jump for your tech deck. And a pipe. ...It needs to be sized down to 2%.

This is an old model I had of a Tech Deck Skateboard. ...Do with it as you please.

I printed some grind rails that fit into my tech deck toy along with the connector peices. 

This is a box for your tech deck or finger board you can use this box for making moves and keep your finger board

I wanted to design a 3d printable tech deck with the colorado mountains on it. So i hopped onto tinkercad and made this. ...Have fun with it!

tech dekc

This is just a Tech Deck ramp that I made for my friend. It's pretty durable if you have the right infill setting. Hope you enjoy! ...Leave comments down below for any complaints or comments.

Hello, this is a Fingerboard / Tech Deck with rolling wheels that I designed in Rhino. Carefully snap the wheels off of the supports after printing, and the wheels will be able to spin. Dimensions are the same as the Tech Deck Fingerboard I have. It...

My nephew just purchased a pack and it included 6 tech decks. So i remoxed this so it would fit all 6 and the extra bolts and screws. If this print was useful, please tip. ... If this print was super useful, print and share with your friends and...

I needed a launch ramp for my Tech Deck and found no good ones online so I decided to make my own! good luck printing it, for maximum efficiency print at as seen size when in your software For my Ender 5 I had to print it at 85% size so I could...

Continuing to play around with Tech Deck obstacles. My countertop is quickly turning into a skatepark. Totally unintentional, but you have to test out your prints right? I may add more depending on what comes to mind. I'll also take suggestions. ...

This is a fun and easy to print teck deck skate park. ...I hope you really enjoy what i have made and have fun.

Fingerboard Tech Deck wheel washer

Simple Playbox for Tech Deck Skating! ... CLICK LINK TO SUPPORT ME -> http://j.gs/GHux