thingiverse controller stand 3d models

This is my design for a Dual or Single Controller holder that also holds your Headphones. There are a few tricks to this print... see below EDIT UPDATE: SOMEONE ASKED FOR A HEX INSERT WITH A DIFFUSER... HERE YOU GO. The Diffuser is 0.3 thick. ...You...

A custom-designed flight controller mount is specifically tailored for a Matek PDB FCHUB-W paired with a F722-STD or compatible board. To install this mount, simply attach the base plate directly into your aircraft model using a strong adhesive.

https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions. I have created a smaller version to fit the right-front corner and the...

The original model was from: https://www.thingiverse.com/thing:5560747 I would like to print in parts, because in real size it was not fitting in my 3D printer, so I made some colors and fittings and also added some fillets and chamfers to facilitate...

It isn't much, but it works. ...2x M4 screws are used to mount.

0.3 layer high works fine

Print at 10% scale

Remix from two awesome things, just get everything done on Tinkercad on 5 mins

I think i've fixed up the gap between the base and the holder and the far improved the logo

Stronger features are simpler to publish.

High= 26 cm Weight= 256 gr

Universal gamepad holder for wall mounting. Fits almost any modern gamepad. ...Mounts with screw or double-sided tape (https://afil.link/tape) Video example: https://youtube.com/clip/UgkxehiB3Xb9-LLpCnvQwtluW6pXpigI5OBD If the gamepad comes with a...

Added the Playstation Logo to the x2 Base.

There are 5 files: - Head - Body - Base - Hand_R - Hand_L All of them are solid

Based on diskcartguy design with added text and receiver holder. print this with supports for the receiver part of it because that has potential to fail, not needed but to be safe i print with supports. ...

Added photos

simple combination made in tinkercad

Clips on the top of a Vertically stored Xbox One

DB Master Roshi

Print in any layer height. ...and do share the end result with us

put some glue or adhesive tape and stick it on the wall

Function and beauty on your desktop... ... Extra materials needed : 2 - M3 x 20mm Screws 2 - M3 Nuts 1 - MicroUSB cable

A little edit to accomadate for the rechargable Battery Kit. ...

Due to Problems with stability, i reinforced it a little.

Easy modification for buddy of mine.

Based on the incredible design by Collingall, I've taken it to the next level by adding some strategic holes that will securely fasten it to the interior of my cabinets' doors.

This device comes with an updated design featuring empty compartments that need to be filled with the corresponding battery packs.