tl4076 3d models

An addon part for the Techduino TL4076 3D Printer sold by Jaycar here in Australia. Designed to fit under a pre-existing screw, it's a print and fit solution for keeping the filament away from the supporting Z-axis rod. Also found out these...

Created this filament guide to make it easier to feed the filament. PLEASE LEAVE SOME FEEDBACK! NOTE: I REMOVED UNNECESSARY HANDLE MATERIAL WHICH GAVE THE MACHINE A COUPLE MILLIMETERS MORE Z-AXIS HEIGHT. IF YOU ARE UNWILLING TO CUT DOWN THE...

note the TL4076 default driver board has no part cooling fan connection points so you could just connect it to 12v. If you want to go all out as i did, you could update your motherboard to arduino + ramps 1.4. which will give you connections for...

I found my Duinotech had issue's on the upright (Z axis), you can realise this by holding the base and the handle at the top, and move it side to side. This plate or spacer, fills the gap where the two main fame piece's meet. I found this stiffens...

z-axis manual adjustment knob to save your fingers ; ) MAKE SURE YOUR STEPPERS ARE DISABLED BEFORE MANUAL ADJUSTMENT!!! i have added my g-codes which is set at layer height: 0.1mm line width: 0.4mm wall thickness: 0.8mm ( 0.4mm x 2 ) top...

Got sick of the bolt on my printers moving about and disrupting the Z-Axis home position, so made this more stable adjuster, complete with a nice easy to use adjustment wheel. Used a M5 x 50 Pinnacle Brand hex bolt and nut from Bunnings for it's...

This mount is designed to hold an E3D V6 Clone hot end I got from E-Bay. It's designed to bolt onto the existing X-axis mount first, then have the Clone E3D mounted to it. While it does hold it well, it does cause the printer to print slightly to...

Remixed my own filament guide for this printer, to handle the filament sensor from http://www.thingiverse.com/thing:3326077 I used the kill button on the front panel for the sensor's signal and the front panel was also able to supply ground and...