tpu band 3d models
87946 3d models found related to tpu band.
thingiverse
... 2 pins for fixing the watch 2 pins to stop the band The title "tenoko" is the back of the hand in Japanese. Referenced work: https://www.thingiverse.com/thing:4164771 I referred to using a pin as a fastener. thank you. ... I hope it helps you
thingiverse
#Scalable TPU Based Spring (TPU & PLA) ##PLA Shelled with TPU Cylinder Acting as the Spring #Shell (PLA) ##Overall Dimensions: Width: 12.7mm (approximately 0.5 inches) Height: 25.5mm (approximately 1 inch) Depth: 12.7mm (approximately 0.5 inches)...
prusaprinters
The print shown above is done with recently opened TPU from Overture (like the morning before posting this), so if you get different results with blobs/underextruding, dry your filament.0.20mm Standard - TPU.json: This config is for all the process...
thingiverse
I designed an experimental TPU battery strap that replaces rubber bands or Velcro straps on Tiny Whoop/toothpick builds with a printable stretchy strap. Pull it tight around the pack and get the teeth to engage into the holes. ...This setup grips very...
cults3d
Experimental TPU battery strap – rather than using rubber bands or a Velcro strap on Tiny Whoop/toothpick builds, I came up with this idea of a printable stretchy strap. Pull it nice and tight around the pack and get the teeth to engage into the...
prusaprinters
I removed the wristwatch band so that it could be attached to the back of my hand. I needed to output with as soft a material as possible, and I output with TPU. Output 4 attached pins and use as follows. 2 pins for fixing the watch 2 pins to stop...