tripod for ipod 3d models
2231518 3d models found related to tripod for ipod.prusaprinters
I realised I had an iPod touch that was not in use - and so now this has been pressed into service to provide the remote control for my camera. It can live in my camera kit within the holder, as there is room for the power charger to connect....
thingiverse
I realised I had an iPod touch that was not in use - and so now this has been pressed into service to provide the remote control for my camera. It can live in my camera kit within the holder, as there is room for the power charger to connect. ...
thingiverse
Customized version of http://www.thingiverse.com/thing:1035943 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=1035943
thingiverse
Mounts an iPod Touch 4 sideways on a tripod. The base has a small support piece built it, snap it off after printing. ... Glue/epoxy the top piece into the base and glue/epoxy a 1/4-20 nut into the base.
thingiverse
Print one out, glue or epoxy a 1/4-20 nut in the bottom, and shoot away! ... To be used on an iPod Touch 5 without a case on.
thingiverse
Clip for Ipod. ...Ideal to bring the ipod, walking, running and more Instructions Print and enjoy
thingiverse
This is perfect for your ipod 5 it is obviously not going to break because of the plastic. ...Once it hardens it is almost invincilbe.
thingiverse
I know that this is not very useful for the rich men out there since there are AquaBox models for this purpose and the correct sizing, but we are talking about recycling, and nights of entertainment with the 3D modeler, awaiting for my printer to...
grabcad
This model is a simple support (dock station) for the PRIUS. ...The station mimic the curve of the dash and the middle section.
thingiverse
Customized version of http://www.thingiverse.com/thing:73622 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=73622 Instructions Using the following options:...