ts215 3d models
13 3d models found related to ts215.thingiverse
The top plate that comes with the Eachine Wizard TS215 is to small and skinny, you cannot mount a gopro or put a battery on top so i designed this. ... Print in PETG for best strength.
thingiverse
I made it because there is no VTX antenna installation place.
thingiverse
Two versions of a rear standoff for TS215 : - FPV Antenna mount - FPV antenna and capacitor mount ( Ø12.5mm )
thingiverse
This is a Top Plate with Runcam 2 Mount for the new Wizard TS215. To get the best stability, I printed it with ABS / Carbon filament with 100% infill. ...Support must also be active.
thingiverse
... ...You can also use other lipos. Did it for the Wizard TS215 made because the model lipos are held with 2 velcro strips and accessories in the only one was there for 1 Velcro tape. ... It prints best with 100% infill and with ABS PETG or carbon
thingiverse
This is a simple holder for the antenna so you can mount it at the back away from the USB connection. It slides over the rear post and provides a ring that you can mount the antenna into. Use a cable-tie too to protect everything in the case of a...
thingiverse
This is a Lipo protection guard for Tattu 4S 1550mAh. The protection provides wells for 2 Velcro straps for firm so he does not solve. ... It prints best with 50% infill and with ABS PETG or carbon or TPU
thingiverse
Имеет встроенный DVR от Eachine Wizard TS215, который начинает запись автоматически при подачи питания, индикатор напряжения для контроля заряда батареи, приемник SM137R Rx. Питание всех компонентов осуществяется через последовательно включенные...