tt01 3d models
94 3d models found related to tt01.thingiverse
Enhanced steering for Tamiya tt01. Add spherical bearing to steering rod which allows shock absorber to work in full range. ...
thingiverse
Tamiya TT01 spare parts for support body. I am looking the part number. i upgrade ASAP. ... enjoy!
thingiverse
Rear Diff Locker to suit Tamiya TT01 / 2 Found someone had already done this afterwards, so here is an optional alternate ... ...:)
thingiverse
Karosserie steher für tt01 sind für niedrige oder sehr flache karosserien entworfen. fahre diese steher bei einer carrera gt karosserie. löcher für die Karosserie splinte müssen selber gebohrt werden. ...
thingiverse
Tamiya Tt01 front bumper frame I drew this from a chinese copy of the tt01. ...So there is a small chance that the dimension are not 100% correct.
thingiverse
If you want to use your Tamiya RC TT01 to drift you have to lock the rear diff. Open diff, remove small gears, insert the block, close diff and good drifting !!! ...This method is more easy and secure than using hot glue.
thingiverse
Soporte para Bumper Tamiya TT01 y compatibles.
thingiverse
Created for Tamiya TT01. ... Steering arm for CVD outshaft.
cults3d
Tamiya TT01 TT02 every version Body posts 100% the same as factory ones, a bit wider, but usable.
youmagine
An additional steering arm for transferring the servo movement to the front wheel axle of the TT01 Type-E chassis from TAMIYA.
thingiverse
I designed this cover for the Tamiya TT01 chassis in order to use the R/C-car in very dirty or icey/snowy conditions. ...I recommend to close the holes in the cover with transparent tape as well as the holes in the bottom of the chassis Print Settings...
thingiverse
If you want to install a hard cased LiPo into your Tamiya TT01 then the original posts are a little bit too short. So I made my own - like the tuned version - but 3mm longer. If you need another size ping me and I can upload. These are 32mm long vs...
thingiverse
This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/kKY14ieCxG2
myminifactory
No support Required To acheive the best results, you can use sandpaper to smooth out the flat surfaces as shown in the images.
myminifactory
Its simple to print and reall works also very cheap and anyone can print it on any printer
thingiverse
upper part 10% infill and TPU left and right part 25% infill and PLA Rubber tpu mount also fits with this mount from Timzzzy : https://www.thingiverse.com/thing:5363298
thingiverse
My body mount broke so I drew this up to replace it. I printed the part in ABS, .2mm layer height, 30% infill. ...I've used it for a few hours with no problems.
thingiverse
Some time ago I've bought a second hand Gemini TT01 full manual turntable, it was all perfect and working except that ridiculously expensive and rare tone arm rest. ... It was split in half and useless so i've tried to print an already made one from the...
thingiverse
Created a shock tower and printed in Low res. Uploaded the g code for high res. First thing that I'm uploading here. ...Please give me constructive feedback so i can deliver better more.