tube cutter 3d models
134608 3d models found related to tube cutter.grabcad
Tube cutter with all its parts. ...you can open it with any version of solidworks and other programs
thingiverse
Tube Cutter. Cut tubes at the specified length, using a scissors. ... Cut using 2.5mm-thick MDF or acrylic board, and attach to a scissor using tape.
thingiverse
This is a tubing cutter that helps cut the ends of PTFE tube square. ...It requires one #11 hobby blade, one M3 x 12mm bolt, one M3 nut, one M2 x 12mm bolt, and one M2 nut.
grabcad
it is a quick model that illustrates the function cutting of tube with of a drill bit in domestic conditions
thingiverse
You just trim the starting end of the tubing off square then slide it all the way into the guide and cut it off with a razor blade. To remove the tube there is a slot at the end to push the tube out. I was able to print it laying flat without...
thingiverse
A simple PTFE tube cutter, designed for to help cut PTFE tube in straight line.
thingiverse
PTFE Tube Cutter The tube hole is 4,5mm Update: New version where the tube hole is 4,25mm
grabcad
A tube cutter for use with 3.18mm od silicon medical grade tube. ...Pre cuts length to 22mm or 27mm
cults3d
PTFE-Tube Cutter. Hole diameter is 4.3mm. Blade gap is 0.5mm. ...I updated the model.
grabcad
Mini tube Cutter, Cutting Capacity: 3 - 22mm, With Hardened Steel Blade And Two Flare Groove Rollers, Cuts Copper, Brass, Aluminium And Plastic tubes.
thingiverse
little ptfe tube cutter to get the perfect 90° cut if you like to tip me click on the side or go to ... ... paypal.me/bassbeat4life
thingiverse
I wanted a simple Bowden tube cutter to get a perfect 90 degree cut. ...the razor blade is press fitted into the blade holder, no glue required
cults3d
PTFE Bowden Tube Cutter 2/3/4/5/67/8/9/10mm for cutter blade- Remix of the nice design made by "eytec" Additional parts needed: - M4x20mm countersunk bolt - M4 self-locking nut - Utility Blade
thingiverse
PTFE Bowden Tube Cutter 2/3/4/5/67/8/9/10mm for cutter blade- Remix of the nice design made by "eytec" Additional parts needed: - M4x20mm countersunk bolt - M4 self-locking nut - Utility Blade
thingiverse
Pneumatic tube cutter designed to use protected back rasor blades. Cuts up to 12mm tube. Screw is a M6x20 or 25 with nut. ... Updated with some notches to hold a rubber band to keep it closed.