usb relay 3d models
61364 3d models found related to usb relay.
thingiverse
... needed. The dimension of the relay board is 33.6 mm x 25.7 mm and of the NodeMCU 31.25 mm x 58.0 mm The 2nd hole at side with the USB connector is for wiring an additional thermometer sensor. ... Additional parts needed 2-6 SPAX 2.5 x 10 screws.
thingiverse
... in my case. ...The design incorporates USB cables as both inputs and outputs, effectively sharing them between the relay module and the device it controls. ...This setup is inspired by the https://www.thingiverse.com/thing:3609611 model on Thingiverse.
prusaprinters
... my case, a water pump). ...This case is designed in a way that the input and output are normal USB cables, which will be shared between the relay and the device to be controlled. Based on https://www.thingiverse.com/thing:3609611 Category: Electronics
cults3d
this is a light design to hold a 4 module relay board in place and it's contacts isolated. While the board is spec'ed to switch higher voltages I use it with 5V and 3.3V on all sides so I did not take extra care to immobilize the outgoing lines any...
thingiverse
this is a light design to hold a 4 module relay board in place and it's contacts isolated. While the board is spec'ed to switch higher voltages I use it with 5V and 3.3V on all sides so I did not take extra care to immobilize the outgoing lines any...
prusaprinters
Just a simple relay holder for this relay https://www.elfa.se/sv/effektrelae-foer-kretskort-rt-1co-ac-230v-32-5kohm-schrack-1393240/p/13721178 Print Settings Printer Brand: Prusa Printer: I3 MK3SRafts: No Supports: NoResolution: 0.2 Infill: 15%...
thingiverse
## Required: ## * 1 x 5V relay, like commonly used for Arduino, Raspberry * 1 x PCB 2x8cm * 1 x USB mounting M-F cable (I use both parts of the cable) * 1 x 3 pin header * 3 x Breadboard cable F-F (to connect to raspberry) * 2 x M3 6-10mm (screw to...