usbc lightning 3d models
11886 3d models found related to usbc lightning.cults3d
Two pieces, one lightning for the wall and one lightning with base It's a great decorative piece.
thingiverse
3D model of a lightning bolt, you can use it to make pendants, earrings, molds ... ...
cults3d
3D model of a lightning bolt, you can use it to make pendants, earrings, molds ...
thingiverse
USBC adapter - holder, that you can stick to your laptop (provided some double sided tape) - this thing is a life saver.
cults3d
Lightning lamp with space for led strip, switch, battery and charging module. It has a hole for hanging, and a base to put on a desk. Dimensions: Height: 200 mm Depth: 30 mm. ... Tira led:...
thingiverse
643852-2 or [one by mojo_replica](https://www.thingiverse.com/thing:863257)) 1x [Makita bettery holder by Henk_i3](https://www.thingiverse.com/thing:1857196) 1x MH-KC24-2 dual channel board...
thingiverse
A spacer to fill in the gap left after installing the GBA SP USBC mod. ... Feel free to use these files on a personal or commercial basis.
thingiverse
My USBC-Dock adapter was not very reliable, slightly tilting and I got a disconnect. That's why I created this stiffener, that hooks into the power plug and half of the USBA connector and grabs from behind around the Laptop to hold the cable in...
thingiverse
I have a computer that only has `USB-C` ports on it. I still have a lot of the older USB hubs and gear so I constantly need a `USB Type C` to `USB 3.0` Mini Adapter. When I need it I always have to hunt around on my desk for it. So I created a...
thingiverse
This is a clamp for the USBc cable, It is a tight fit once in place you can make sure it wont come out by extending the two screws and placing nuts on the back. ... Made in Tinkercad.
thingiverse
A holder for USBC wire on a Richer 25312. Its made vor an XCover4, but schould fit on many smartphones. Print in ABS/ ASA/ Greentec or similar. ... Not PLA or PETG.
thingiverse
... ... So I made one for the Thinkpad USBc dock. You can mount it under your desk, with double sided tape, Gorilla-tape will work fine. ... There are two options, one with a full cover, and one with areas free (like in the photos, saving PLA)
thingiverse
Here is a USBc cable support for the rear cables, I found mine is a little loose so this is my solution. You will need to drill two 4mm holes in the back of your printer for this to attach firmly. YOU DO THIS AT YOUR...