vortex 180 3d models
18951 3d models found related to vortex 180.thingiverse
TPU ufl Axii mount for the Vortex 180. This slides through the hole where the SMA connector is from the factory. ... The V2 file has a more snug fit, but is more difficult to install.
thingiverse
I like to fly larger packs on my Vortex 180, but the back of the battery isn't secured with a strap and can slide close to the rear props. I created this simple battery wall that you screw down on the rear arm-plate screws and it prevents the battery...
thingiverse
remixed from IRC Vortex 180 Axii Mount by Porksoduh i added rx antenna tube holders V2 has thicker tube holders for slighty more rigid antennas. v1 tubes holders are fine but they bend a little too easy for me, concerned they will hit props if bent...
thingiverse
This cover is for a Vortex 150 / 180 To install a dvr on the vortex at minimum cost using original camera It uses the Rumcam DVR https://www.getfpv.com/runcam-mini-fpv-dvr.html https://shop.runcam.com/runcam-mini-fpv-dvr/ Fits on the Vortex without...
thingiverse
FYI, The green unit is the Vortex 150 and the white is the Vortex 180. ... Manual - https://www.runcam.com/download/split4k/RC_Split_4k_Manual_EN.pdf RunCam - https://shop.runcam.com/runcam-split-4/ Camera available here ...
thingiverse
I couldn't find any session mounts for the ImmersionRC Vortex 150/180, so I took what was already existing and remixed them together. This is V2 as V1 was scrapped since it too flimsy to support the session. I added a few reinforcements and have...
thingiverse
since I got the vortex 150 it became one of my favorite quads and I really wanted to record HD video from it and the runcam split was the only camera that I think it will work with out affecting the flight characteristics of the quad to much (CG) it...
thingiverse
Version 1 with Antennae out back. ...V2 coming with Antennae out top.
thingiverse
This is a protective foot / slider for the immersion vortex 150. I think it will fit the 180 as well. ... I printed in PLA 100% infill.
grabcad
Vortex is a clean shaped papertowel holder for Umbra. It can be used either on the wall bothe vertical and horizontal. And it can be use independently in the table. It is made of 4 pieces in total. - a wallmount - a flat profile o-ring - a paper...
thingiverse
... ...http://www.thingiverse.com/apps/customizer/run?thing_id=53451 Instructions Using the following options: approximate_number_of_teeth_on_sun = 9 number_of_planets = 5 tol = 0.35 nTwist = 1 w = 6.7 P = 45 T = 50 D = 180 number_of_teeth_on_planets = 7
thingiverse
76 inches (193 cm) tall fully assembled, cut into 180 mm sections for easier printing. There are two registration holes on each end to line up each section easily. I have also included a model for the registration pegs to assemble (will need 20...