winbook tw100 3d models
13 3d models found related to winbook tw100.thingiverse
Whenever you pull the TW100 towards you the tablet falls backwards :/. So This little attachment grabs the kickstand and makes sure that doesn't happen. ...The clips on the side are there so you can clip it to the keyboard case fabric when it is all...
thingiverse
This is an attempt to design and print a handle for easier holding of the WinBook TW101.
thingiverse
Here's a solid and simple stand for the Winbook TW8xx series of tablets. ... It's sized to print on the M3D Micro (80 mm maximum dimension).
thingiverse
... at the following website. http://www.youmagine.com/designs/8-winbook-tw801-tablet- mount. I removed the lip and bottom screw mount brackets that made printing this tablet mount a pain. ...Also repositioned it to fit horizontally on the print bed.
youmagine
I have been using a Winbook TW801 8" windows 8.1 tablet recently to drive my printer. ...This mount aligns the camera centered on the print bed on my Eustathios printer so the tablet and camera can be used for slicing and remote print viewing.Visit my...
thingiverse
The Winbook is currently used in conjunction with a Monoprice 12 x 9 graphic drawing tablet to allow my kids to draw freehand images. The tablet can easily handle the drawing tablet hooked to it. The Winbook is also attached to a 24 inch 1080p...
thingiverse
It should work with all Panasonic, Ion and WinBook action cameras as they all look to come from the same manufacturer. Print in the orientation shown with no supports. I added a brim just to make sure it didn't warp up off the bed. ... There's a hole...
thingiverse
... can be used for pretty much anything you think of so have fun. I printed at 100% infill. Went through a whole roll of filament until I got it right. Enjoy. The Mount for the 8 inch Winbook can be found here: http://www.thingiverse.com/thing:1429093
thingiverse
Just a coupler to arrange a winbook keyboard to a cube iwork11 tablet win10 pc. It has 2 items as shown in pictures. It can keep magnets to firmly put on the tablet and the connector to wire keyboard to pc. You also need 4 - 6 screws (1 cm long and...
thingiverse
I control it with a Winbook tablet running Windows 10 and Jinx! I soldered the wires directly to the Arduino Nano's (I did not solder the pins onthe Arduino). As you can see from the pictures The USB cables plug in on one side and I have the...
thingiverse
Specifically made to support a WinBook TW700 (http://www.amazon.com/dp/B00QDJ2FUK) which I use to run the M3D Micro without it needing to be connected to my main desktop. You'll need to use the M3D software to rotate this part to fit on the print...
thingiverse
... about their RCA Cambio tablet (10.1") The pinout only has 4 pins and it is (same orientation as above) 5V DP DM GND There is room inside this keyboard to install a very thin hub, BTW. Not so much room in the Winbook, however. ... Enjoy!