window latch 3d models

First, I started by sketching out the outline of the front view of the sketch. I used the dimensions in the blueprint to sketch out guidelines for me to use to sketch it out. I used the line tool and the center line tool the most in this project.

Use for Door Cabinet....

Second try

First I made a lot of dimensions to make it easier to sketch out, I started on the right slant and worked clockwise. ...After I made the sketch I extruded 45mm.

Mass = 1066.52 gramsVolume = 135002.52 cubic millimetersSurface area = 18681.37 square millimeters Process:I sketched the whole part in just 1 sketch and then did the boss extrude. ...It was relatively easy it's just figuring out the dimensions.

Plugs that can be used on the model, positioned using rubber bands.

Mass = 1066.52 gramsVolume = 135002.52 cubic millimetersSurface area = 18681.37 square millimeters

A straightforward fastener designed to secure two components together. ...It requires only two #8 screws for installation.

I started by sketching out all of the straight lines and dimensioning them as such. To create the curved geometry, I used two different types of arcs. I created a centerpoint arc, using the midpoint of the long line in the bottom right as the center....

Bolts/Nuts needed: 4 M3 x 06 Socket head bolt 1 M3 x 35 Socket head bolt 5 M3 Nuts

Part of Obtaining SolidWorks Certification

step1: sketch geometry according to the blue prints (( !! crucial !! ...- when sketching make sure the arcs are fully defined first, then make the line under the whole cut out concentric with the axis))(note) the axis point in the blue prints can be...

I used the line tool to create my shape than started to dimension everything to the correct length. I used the arc tool so i could make my curves and everything. ...I than extruded than and but a circle on the shape and cut it through the entire shape.

Steps:1. Started the sketch o the 40mm ark and dimensioned as I went, when I got to the corner with the two tangent arcs, I made the horizontal line coming from the 45 angle coincident with the point of the 29mm arc.2. Extruded to part width3.

I started by sketching out all of the straight lines and dimensioning them as such. To create the curved geometry, I used two different types of arcs. I created a centerpoint arc, using the midpoint of the long line in the bottom right as the center....

This is an easy-to-use, straightforward equipment that simplifies tasks and enhances performance. ...Its user-friendly design ensures hassle-free operation, making it perfect for those who prefer a no-nonsense approach to hardware.

The material used is AISI 1020, and it has a mass of 1066.52 units.

steps:1. created left edges sketch first2. added the curves, created relations and dimensions3. worked on right side of sketch4. added hole in left center of sketch5. added finishing relations with respect to the plus reticle thing6. extruded7.

Steps:1. Started the sketch o the 40mm ark and dimensioned as I went, when I got to the corner with the two tangent arcs, I made the horizontal line coming from the 45 angle coincident with the point of the 29mm arc.2. Extruded to part width3.

step1: sketch geometry according to the blue prints (( !! crucial !! ...- when sketching make sure the arcs are fully defined first, then make the line under the whole cut out concentric with the axis))(note) the axis point in the blue prints can be...

Solidworks Certification test

I utilized a secure locking device to maintain closure of the entrance gates surrounding my living quarters.

Door latch Asmith BZ-18

Door latch for double doors

Door-Latch. ...Print and enjoy

latch for boxex or trunks