working at buckle 3d models
822951 3d models found related to working at buckle.myminifactory
Working version of the Deadpool Belt Buckle. Supports are needed for the main part, the detachable strap part does not need any support. I put load tested the print with around 25 pounds before I took the picture. ...printed at .2mm with 10% infill.
myminifactory
The buckle locks and unlocks by turning the circle on the front of the buckle about 15 degrees. the yellow pictured one is printed at .2 mm, the other picture is an exploded view of the parts. For belt length print the belt pieces until you have...
thingiverse
#Take a look at my other projects: ##Watch https://www.prusaprinters.org/prints/8557-3d-printed-watch https://www.thingiverse.com/thing:3949624 ##filament buffer (airtight & easy to fill) for Prusa MMU2.0 thing:3668570 ##LMGTS filament...
sketchfab
My 3D asset generated with photogrammetry software 3DF Zephyr v3.702 processing 47 images
thingiverse
... if you don't need them. See my other thing: "Strap buckle for loop at end of leash" for more pictures". I usually have to scale by 10 all my drawings when they go into my slicer. ...It maybe because I draw them in mm and slicers may expect cm.
cults3d
Prevents the buckle from coming down to the ground when removing the belt, broken on my Citroën C3 MODELS
thingiverse
I created this female buckle to serve as a replacement for the original (after my dog chewed it). I took advantage that the leash had a nice loop where the broken female buckle was. The leash width is 1inch. You'll need 1.8-1.9" long by 1/4" bolt...