wrench holder 3d models

Wrench Holder

Model of wrench holder ready for 3D printing.

8 wrenches holder designed in freecad. Update 22-06-2015: New version upload, including the freecad file. ... ...

A simple little holder for a set of 5 wrenches held by friction. ... They are stacked so you can read the sizes on the wrenches when they are in the block.

just a small wrench holder i designed

Table-side wrench holder. ...for two wrenches up to 30x10mm section

Just a metric wrench holder for some of my Craftsman wrenches. Handy dandy. Print Settings Printer: DaVinci Jr. ... Rafts: No Supports: No ...

This wrench holder are printed in one piece without support and doesn´t require glue. ...Use two of the existing top screws for mounting.

This wrench holder are printed in one piece without support and doesn´t require glue. ...Use two of the existing top screws for mounting.

Remix ofhttp://www.thingiverse.com/thing:3242936 Wrench Holder (parameterized) by dede67 My attempt to translate and add documentation. ... WORK IN PROGRESS!

This is an allen wrench holder for the sizes: 1.5mm 2mm 2.5mm 3mm 4mm 5mm 5.5mm 6mm

Standard wrench holder to go along with my metric one for my Craftsman wrenches. Mmmmmm Imperial units.... wait, that sounded bad. Print Settings Printer: DaVinci Jr. ... Rafts: No ...

I needed to change the draw mat on my wrenches due to age. ...My existing wrench holders were full of 2 sided tape and I didn't want to bother removing it all, so I created suitable replacements.

Mini wrench holder for a set of low profile wrench. Designed to fit 2mm thick wrenches but the fit and finish of the set that i own isn't great, so your mileage may vary. ... Print Settings Rafts: Doesn't Matter ...

Compact Allen wrench holder to be placed on any metal surface to keep your tools easily organized and accessible. This is made to fit standard (SAE) size allen wrenches. ...

Remix of a hex wrench holder I saw online somewhere, use a captive 5mm x 3mm cylinder magnet in the base (pause while printing). Holds 4 hex wrenches, 2mm, 2.5mm, 3mm, and 4mm. ...Printer -- Eustathios Filaments: (full list can be...

mount to the wall, holds wrench's or other tools

... part with a density of 75% to make sure that the legs were strong. Important The holes in the allen wrench holder are intentionally small. ... Use a drill to enlarge the holes so they fit your Metric or SAE alan wrenches snugly.

A sturdy and filament-saving wrench holder for these [metric] sizes: 5.5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 19, 20, 21, 22 Six screws in M4 (and an M4 thread cutter) are needed. The length of the screws is not that...

Made a hex wrench holder for the ones that come with the Di3, stuck it to the side frame of my printer with some double sided tape. ...Print Settings Printer: Wanhao Duplicator i3 Rafts: ...