0.4L Circular cabinet for Micro

prusaprinters

<h3>Welcome to 0.4L Circular cabinet for Micro</h3><h4>A quick cabinet suitable for small PC Speaker / Laptop use</h4><p>&nbsp;</p><p>This 0.4L cabinet uses approximately 100g of filament and typically will be a sub 8h long print, even on a ender 3. The main cabinet is a single solid piece and prints with no support material required.</p><p>Micro simply gets glued and pushed into the front. Using a PVA based glue is a good idea as it works well and can be removed later by applying some water to the join. The back has a hexagon shaped back to fit either a Sealed or Aperiodic back cap.</p><p>The Sealed cap is the simplest but will likely result in a big bass bump.</p><p>The Aperiodic cap has to parts which screw together. Within these pieces you place some tissue paper and compress it. How much will effect the bass bump, so using blu tack to experiment first is suggested for this one.</p><p>The additional 2 holes are to pass your speaker wires through and glue into place.</p><p>Frequency response with or without the additional 220uF cap will be around 150&lt;16,000Hz</p><p>Link to Micro - 3cm Full Range Speaker Driver:</p><p><a href="https://www.printables.com/model/233025-micro-3cm-full-range-speaker-driver">https://www.printables.com/model/233025-micro-3cm-full-range-speaker-driver</a></p><p>If you are looking for the more powerful version of Micro, Micro+ which uses the Fountain / Peony / Firecracker motors, please check and consider becoming a Patreon. Doing so helps the project and gives you access to additional cabinet designs.</p><p><a href="https://www.patreon.com/polymate3d">https://www.patreon.com/polymate3d</a></p><p>Finally, any questions, feel free to email me or DM me on Twitter!:</p><p>polymate3d@outlook.com</p><p><a href="https://twitter.com/Polymate3D">https://twitter.com/Polymate3D</a></p><p>Happy Printing!</p><p>&nbsp;</p>