1/1400 Scale Constellation Class

thingiverse

Currently working on re-meshing this model in blender to remove any non-manifolds: August 8, 2019 - Fixed the bottom saucer (uploaded Saucer_Bottom_0_Manifolds_2019.stl) this one I had to fix the bottom of the model, Blender was not showing any non-manifolds but there were some where the model touches the plate. August 11th, 2019 - Working on fixing the (Nacelles_Top_Bottom_Fixed.stl) file by separating each piece into it's own file and fixing the many non-manifolds. Uploaded (Torpedo_Tubes_print_two_0_manifolds_2019.stl) which is the small torpedo tubes that rest between the engine nacelles. Print two of these December 18th, 2017 - Uploaded Saucer_Middle_0_Manifolds_2.stl - Fixed all non-manifolds in Blender, also re-meshed the model to save filament with the center section open. Opened in Cura and Slic3r Prusa Edition and looking good December 17th, 2017 - Uploaded Saucer_Top_0_Manifolds.stl - removed all non-manifolds in blender, tested in Cura and Slic3r Prusa Edition, looking good December 1st, 2017 - uploaded Saucer_Bottom_0_manifolds.stl; took me awhile to get rid of all the non-manifolds and most of the model has been re-meshed in Blender; Tested in Cura and Slic3r Prusa Edition and looking good in both. August 29th, 2017 - moved this back into a Work-in-Progress; will be going through in blender looking for non-manifolds and removing them from the model; currently working on the Miranda Class fixing that one This is a remix of the Constellation Class Cruiser uploaded by nd4spd1919 Scaled at 1/1400 scale just like the ERTL Kits (Enterprise C, D, E, Voyager 3-piece set) Nacelles_Top_Bottom_Fixed.stl - Print this twice as it is the same for top and bottom engine nacelles Impulse_Area_Detail pieces print two of each Saucer_Bottom_Detail.stl is that small gun like protrusion from one of the domes, I only uploaded half of it as the other half can be loaded and mirrored Print Settings Printer: Anet A8 Resolution: .1 Infill: 5%