1/6 Scale RC Stand (3 Versions)

thingiverse

**Large Scale R/C Truck Stand I built for my Losi Super Baja Rey.** 100% Printed All Pieces have been uploaded Let me know if you have any issues. Some thumbnails are not showing for some of the STL files. Thingiverse has a lot of bugs. I have uploaded new versions of the Center and Saddle Arm. Version 2 of these two things are larger than version 1. The arm are longer and beefier Version 1 worked fine but I wanted a longer arm and decided to make it stronger at the same time. A picture was added showing the size difference between version 1 & 2. I added a friction bolt to Center V3. Otherwise it is the same as V2. I used the knurling bolts that was modeled by akira3dp0. Thanks https://www.thingiverse.com/thing:1460364 I used the smallest bolt available and then scaled it down by 50%. The head was still too thick so I reduced the head thickness by another 4 mm. I have test printed all pieces and I am very satisfied with their fit. They are scalable as long as you scale all 3 axis the same amount. If you want to scale the flexible runners on the z axis to make them thinner that would be OK too. Tight Tolerances, but everything will fit with a printer tuned correctly. Supports will need to be fairly clean when removed. If you have elephant foot on your prints they will need to be cleaned before piece will fit. **Single Saddle Stand - .12 Layer - 30% Infill** Print 1 of each of the following Base -- 28.2 Meters PLA -- 20 hours 38 minutes -- Supports YES (from Platform Only) Threads V2 -- 11 Meters PLA -- 8 hours 5 minutes -- Supports NO Saddle -- 6.8 Meters PLA -- 5 hours 5 minutes -- Supports YES **Double Saddle Stand - .12 Layer - 30% Infill** Print 1 of each of the following Base -- 28.2 Meters PLA -- 20 hours 38 minutes -- Supports YES Threads V2-- 11 Meters PLA -- 8 hours 5 minutes -- Supports NO Center V2 -- 13 Meters PLA -- 8 hours 56 minutes -- Supports YES Print 2 of each of the following Saddle -- 6.8 Meters PLA -- 5 hours 5 minutes -- Supports YES Saddle Arm V2 -- 4 Meters PLA -- 3 hours 7 minutes -- Supports No T Pin -- 1.2 Meters PLA -- 1 hours 7 minutes -- Supports NO **Plate Stand -- .12 Layer - 30% Infill** Print 1 of each of the following Base -- 28.2 Meters PLA -- 20 hours 38 minutes -- Supports YES Threads V2 -- 11 Meters PLA -- 8 hours 5 minutes -- Supports NO Plate -- 24.7 Meters PLA -- 18 hours 2 minutes -- Supports NO Print 2 of each of the following Flexible Runner -- 18.7 Meters TPU -- 8 hours 30 minutes -- Supports NO (8 mm thick can be scaled 66% or 50% to reduce thickness)