10.1 HDMI TFT Screen enclosure for smaller printer sizes

thingiverse

Update: there's a full size design for larger format printers available. See Remix. This is Version 2 of a 10.1 inch TFT enclosure / case. It is designed so it can be printed on a 220*140 print bed. The finished product photos are from Version 1. I didn't upload first version, but decided to share improvements to the design. V2 has a bit more room for the mainboard, so cables are under minimal stress. Also an opening for the screen flatcable to pass through to the mainboard. The screen I have is a 1280*800 10.1" RGB TFT EJ101IA-01G LCD screen display with remote driver control board 2 AV, HDMI & VGA. I use it with a Rasberry Pi. You'll need 5 push buttons. One hole is left open and has the IR receiver behind it. Print Settings Printer: CTC Bizer Dual Rafts: No Supports: Yes Resolution: 0.2 Infill: 25% Notes: I used supports on the left & right rear panels only since they have 2 levels to leave sufficient space for the somewhat thicker lower rear area of the screen. Post-Printing Both halves are "clamped" together using 4 M3x12 bolt and 4 M3 nuts. You can use these holes to accomodate extra stand support or wall mount. I haven't made any yet because I'm waiting for a small soundbar I want to incorporate. The front and back panels are held in place by using microscrew size 1.7x4mm. Board covers and boards use somewhat larger screws. (whatever you might have.....)