10 x 10 Board Game Challenge w/ Meeple

thingiverse

This is a smaller 10 x 10 board game challenge. It is a 2 x 10 w/ 4 x 5 challenge. It has two games at 10 plays a piece, and four games at 5 plays. Use a brim or raft when printing as this will take up a large portion of the bed. No supports are needed. I printed this on an Ender 3 Pro. The meeple provided in this should fit right into the challenge board. They are *slightly* smaller than the holes on the challenge board so they can slide in. If any modifications are made, be aware it will likely affect the fit of the meeple. The circular inlays are for neodymium magnets which can be finger pressed into the circles. I had these already from other projects so I designed the wells around them. Write the name of the board game you're playing, then place it in the square inlay, then push the other magnet in place and it will hold it until you want to change it out. The magnets are 1.5 mm thick, 12.5 mm diameter. They can be found pretty much anywhere and any strength rating would be sufficient for this project as it's just holding a single piece of paper. I printed at 0.15 layer height with 25% infill and it took about 9 hours. I feel like this is the sweet spot.