1515 extrusion twist in led strip clips

thingiverse

Update: Added an open wider version of the clips. When looking from the front at an a lower level you could see the edge of the strip; I printed around 45 off the open clips and inserted them touching from one end to the other, thus covering the bottom edge of the LED strip. I did decide to use one old closed clip on each end to make sure it stays in place though I doubt it is needed. Twist and lock clips for 1515 extrusions and 10mm waterproof LED strips. I used these clips to install an LED strip in the front of my Railcore printer; In the bottom side of front top extrusion and covered by the front face of the printer. I include a versions with 0.96mm or 1.44mm thick walls; Intended to be printed with a .40 nozzle and .48 pathways.