Modular plug holder(s)

thingiverse

There are two versions of this, a custom long version which you can print as many middle sections for as you like or just the end pieces, and a single version. The example model is meant for show. A few notes: - I did my best to not make it overly long but still have enough width for plugs. - The end-to-end snap fitting is intended for gluing. - There's a 7mm gap for the cable. With a sloping design to keep it in place unless the plug is overly heavy, I can do a new interation for this if I get around to testing and accommodating for that. - Designed to be stuck on to a table edge. - I may implement a print in place sliding latch system later down the line.