18 tooth T5

thingiverse

This customized design of the motor shaft is available at http://www.thingiverse.com/thing:16627, created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627. Following the options provided, we have a custom setup: Instructions Using these options: pulley_b_ht = 10 (pulleys set at 10 units high) m3_nut_depth = 2.7 (nut depth adjusted to 2.7 units) additional_tooth_depth = 0 (tooth depth kept standard) motor_shaft = 5.2 (shaft size optimized for performance) idler_ht = .5 (idle unit height optimized for reduced vibration) nut_shaft_distance = 1.2 (nut positioning calculated for stability) nut_angle = 180 (nut alignment ensured at maximum angle) idler = 1 (default idle unit set to active state) no_of_nuts = 2 (standard setup with two nuts utilized) additional_tooth_width = 0.2 (extra width for improved precision) m3_nut_flats = 5.7 (optimized flat nut dimension for performance gain) pulley_t_ht = 5 (top pulley unit optimized for higher clearance) teeth = 18 (18 teeth units engaged in this assembly design) m3_nut_hex = 1 (single hex bolt employed) profile = 6 (six-profile system optimized for balanced dynamics) m3_dia = 3.2 (medium-sized diameter for increased torque handling) retainer_ht = 1.5 (height setting enhanced by .5 units to accommodate all components) retainer = 1