1806 to 2204 Motor Mount Extension for a WingWing Z-84

thingiverse

I needed an adapter to mount a Emax 1806 motor on the back of my WingWing Z-84, however the 1806 motor is too small to be a direct replacement as the prop would hit the back of the WingWing Z-84. This adapter matches the standard hole mountings 16mm / 19mm of the WingWing Z-84 and extends the mount out ~29mm so that the smaller 1806 motor & 6" propeller can be used for a longer, more efficient flight. You'll need to finger tighten the bolts in first, then use the allen key to tighten them. Thread lock is suggested! Print with an infill of at least 30%, this is a motor mount after all! You're very welcome to edit & improve upon this design! Matt Print Settings Printer: Delta Printer Supports: Yes Resolution: 0.2 Infill: 30% Notes: It's for a motor, so don't skim on the infill! 30% minimum.