1976-1982 Honda CT70 Killswitch

thingiverse

This is a 1976-1982 Honda CT70 Killswitch. It probably also fits a lot of other vintage Honda motorcycles from the same years. Although the 3D model is functional, I take no responsibility for physical or material damage that may occur using this part, use at your own risks! Material needed to complete: * 8-32x0.5 inches bolt (Self threaded in the switch, similar thread/length screws should work) * Thin conductive metal strip (I used a clipped portion from a male Deans T-Plug) Assembly: 1. Open up the throttle console by removing the 2 screws. 2. Remove the old switch by removing the small U clip holding it in place inside the console. 3. (Optional) Clean up the 3 terminals on the switch, I used a brass Dremel brush 4. Using epoxy or hot glue, stick the small metal part on the small indentation on the bottom part of the switch. Make sure to center it. 5. Screw back using the 8-32 bolt, it should thread itself in the killswitch. Screw tight enough so the switch does not move by itself, but not too much to allow rotating it. 6. Using a multimeter on resistance setting, test the switch. On the center position, the circuit should be opened (infinite ohms). Turned either way, the circuit should be closed (0 ohm).