1992 Ford Ranger Door Handle

thingiverse

Driver's inside door handle housing and handle itself broke off, or was broken when I was gifted this truck. Here's my fix! You'll see the first draft which was just a placeholder to see if the overall size was good. Good enough for me! I did adjust the height of the layers since there was a bit of a gap between each layer but still held up. I dropped each layer 1 mm on the next rendition and rounded a number of piece better. The cut outs for the cable and cable stop screw hole aren't perfect. Instead of going back to the drawing board I pulled out the drill and angle grinder. I also had to sand on the handle pivot end to slide around easy. The handle does pop out at times, but if you're mindful with pulling the handle and pushing it back in...no worries. Otherwise, feel free to modify and fix my design! All in all, it works!! And it's strong!! Print Settings Printer: CTC Dual Rafts: Doesn't Matter Supports: Yes Resolution: .20 Infill: 35% Notes: I went heavy on the infill because I wanted strength in this piece. Worked great!