1st stage custom door wedge for cage

thingiverse

So this is a thing i started designing over on my Facebook page, there i uploaded pictures of the measurements and sketches i did of what i wanted it to look like. I started out measuring the size of the cage door and how far it stuck out once it was fully out and level, then i did the same for the side of the cage and measured from the bottom of the door to the bottom most part of the bars (where the bars met the plastic base of the cage), then i went over to 123D Design and made some basic shapes along with matching it as close to the design and measurements as possible. Once i was done it was over to the 3D printer to print it and see how it turned out. This wedge i made for a 77 x 47 x 58 cm large cage that is suitable for my two rats, the bar spacing is 1cm and the door on the side is 19cm tall and 18cm wide. There are 3 stages of this make i will be uploading and each one is customizable for scaling and design to fit the right space for you. my facebook page for other makes: https://www.facebook.com/WolfsPropCreations/?modal=admin_todo_tour