2-way & 3-way Gardena hose divider / splitter

thingiverse

Hose divider / splitter with Gardena fittings. Should also work on gardena-compatible "quick-click" systems, e.g Hozelock, but not tested. There's two versions, a 2-way, and a 3-way. You need 3 O rings, which you can scavenge of a gardena fitting or buy ($2 for 50 on the usual direct-from-china shopping platforms) If your printer can do 40mm bridges (most can), you can print without support. If you do use support, make sure it's set to "touching the buildplate only". For PLA, I'd recommend 4 perimeters at least, otherwise you may get small leaks between the layers. If your printer uses a moving bed, orient it lengthwise on the movement axis, so the back and forth is less likely to make it wobble off. Brim or raft may be needed, depending on how your adhesion is. The Gardena connector in the model was reused from the ["Pilzregner" by marcus16423](https://www.thingiverse.com/thing:2996712), Thanks!