2-way and 3-way Marble Spinner

thingiverse

These are two simple Fidget Spinners, each takes less than an hour to print, they require no supports. they are sized for longboard bearings, and to add weight they are perfectly sized for marbles to snap into the end. to be fair, I didnt use marbles from a marble set, I used marbles that i cut out of spray paint cans, but if they are the same size they should work fine. I plan on uploading a version that works with steel bearings too. as you can see one of the buttons has a hole in the top, i designed it so that you could drill a small pilot hole through it into the other bearing and use a small screw to secure them to the spinners