2 x 4 Marking Gauge/Ruler

prusaprinters

<p>A gauge used to quickly mark locations on the ends of a 2 x 4" beam (actually 1.5" x 3.5" = 38.1 x 88.9 mm).</p> <p>Based on this: <a href="https://www.amazon.co.uk/Rakuda-2-4-Square-Ruler/dp/B001Y51VUI?tag=thingiverse09-20">https://www.amazon.co.uk/Rakuda-2-4-Square-Ruler/dp/B001Y51VUI</a></p> <p>There's another version with a third side to fully lock the gauge relative to the beam.</p> <p>Edit the SLDPRT as you wish, but be warned that the VarPattern features take a bit to render.</p> <p>You need to disable trailing zeros under Document Properties, quit, &amp; restart SW so that the numbers render without x.00.</p> <h3>Features</h3> <ul> <li>1 &amp; 10 mm graduations</li> <li>2 sides: 89 x 89 mm &amp; 38 x 89 mm</li> <li>50 x 50 mm square on the main face with hole pattern on the corners &amp; midpoints</li> <li>89 mm side split into thirds, quarters, &amp; halves on all edges &amp; the corner</li> <li>secondary face: hole grid spaced along half &amp; quarter of 38 mm side, &amp; quarter of 89 mm side</li> <li>choil cut out of contacting inside corner</li> </ul> Category: Tools