2020 corner mount for notebook clip-on cameras

thingiverse

Easy to use mount that attaches to the corner of printer frames using 2020 railing such as CR-10, Ender 3, and others, allows easy mounting of clip-on cameras that are often used for notebook computers. I had an old Creative Labs camera sitting around, and it works great with my Raspberry Pi and Octoprint for monitoring and time-lapse prints. Two heights are available, 55 and 75 mm, although this mount is easy to adapt using your favorite design program for any height (or create an adjustable mount easily by adding a sleeve and set screw). Uses M3 screws and 2020 T-nuts. Anywhere from 16-20 mm screws should work, and even shorter ones since the holes are recessed. I also included a simple 2mm tall spacer that could be used if your bolts are just a bit too long and bottom out against the rail.