2020 Motherboard mount

thingiverse

I didn't see a good motherboard mount for 2020 extrusions on thingaverse so I made my own. It prints tight, so you'll need to spin the mount a bit when putting it into the motherboard. Its tight intentionally so that no screws are needed to use them. However I did place a screw hole into the mount in case you want to make sure it doesn't flop out. Once all your mounts are in place, you can slide the mobo into your 2020 extrusions. 1x 2020 motherboard.stl is as pictured, this is what I use. 1x 2020 motherboard LEVEL.stl is the same object but with the top flush with your motherboard, so there isn't a gap between the screw and the mobo. Use this only if you plan to use screws.