2022-2023 Honda Grom Rear Fender Eliminator

thingiverse

Just got a new 2023 Grom a couple of weeks ago, and realized that there were no models for a fender eliminator. You'll find the FreeCAD file attached to this thing. Please feel free to modify and re-upload, I just ask that I get attributed. Printing: -Minimum 40% infill. I'd rather someone doesn't lose their plate because of this. -DO NOT USE PLA. This print should be printed in PETG at minimum: ABS recommended. -Bed adhesion and supports as needed. Installation Instructions: 1. Remove and disassemble the existing fender. 2. Mount the Plate Light base to the fender eliminator and bolt it on, checking orientation of the light cover. Leave the light cover off for now. You'll need it off to access the mounting screw holes later. 3. Mount each of the blinkers, and bolt them on. Again, check your orientation. 4. Route all of you electrical through the electrical pass-through provided in the fender eliminator, and connect the blinkers to their color coded positions on the wiring harness. 5. Route the wiring harness through the body, connect the harness to the bike's electrical system, and test both blinkers, and plate light. 6. Once tested, bolt the fender eliminator to the bike. For this, I used 4x m5x16 bolts, washers, and nuts. 7. Mount the plate light cover. 8. Mount the plate carrier, and adjust to desired position. I used 2x m5x16 bolts, washers, and nuts for this.