20cm glass supports (stock Micromake D1 bed heater)

thingiverse

I couldn't stand the stock Micromake glass clips as they were too tall, hence the part fan duct of the stock extruder would crash into them on bigger prints. So I made some low profile glass clips/clamps to hold it in place without protruding above the glass surface. The glass is kept in place purely because it fits between the clips snug enough..and then gets properly fixed by the screws. Printed in PETG with fairly little infil to keep them slightly flexible so they fit the shape of the glass better. This was made for a 20cm round glass. Happy printing :) Print Settings Printer: Micromake D1 Rafts: No Supports: No Resolution: Any Infill: 25 Notes: (For some reason Thingiverse previews it in an odd orientation. Make sure to lay it flat on the bed) I printed this in PETG with fairly little infill for a bit of flex. Feel free to experiment - it shouldn't make much difference though.