20mm Calibration Cube for Dual Extrusion

thingiverse

This is a standard 20mm calibration cube, but with two colors so you can calibrate your dual extruder set up! In my picture you can see I printed two of them, at 90 degree angles with the colors switched. This was to check differences in x-y alignment, and test stringing since my new set up is bowden fed. That's about all there is to it. Have fun! Print Settings Printer: Homemade Rafts: No Supports: No Resolution: 0.2mm Infill: 20% Notes: The sections of color on each layer are so small that this will be a solid cube of plastic (infill doesn't matter) with most 3D printers and most stock settings. How I Designed This Designed in Fusion 360. Sliced in Slic3r.