20mm PVC Pipe With 1.25" Magnetic Mount Clip

cults3d

This is a PVC pipe clip with a magnetic base to hang Christmas Lights on. This was designed for 20mm schedule 40 PVC pipe. These are available in lengths of 1", 1.5" 2", 2.5" & 3". The length is from the center of the pipe to the base of the shaft holding the pipe. The round base thickness is not included in that dimension and adds an additional 0.25" to the overall length. You can purchase the magnets these were designed for by following the link below. The magnet can be glued on or screwed on using a thread forming screw. There is a small hole in the base that is 10mm deep where a screw can be screwed in. A huge shout out to Clay Warling for helping with the initial testing and the sweet photos! Neodymium Disc Countersunk Hole Magnets When printing these parts, they should be printed flat on your print bed with the round base perpendicular to the bed and will require the use of supports. 20mm PVC 1. Magnetic PVC Mount Clip 2. Magnetic PVC Mount Clip with Wire Channel Looking for other pipe versions? You can access those below: 25mm PVC 1. Magnetic PVC Mount Clip 2. Magnetic PVC Mount Clip with Wire Channel 1/2" PVC 1. Magnetic PVC Mount Clip 2. Magnetic PVC Mount Clip with Wire Channel 3/4" PVC 1. Magnetic PVC Mount Clip 2. Magnetic PVC Mount Clip with Wire Channel 1/2" EMT 1. Magnetic EMT Mount Clip 2. Magnetic EMT Mount Clip with Wire Channel 3/4" EMT 1. Magnetic EMT Mount Clip 2. Magnetic EMT Mount Clip with Wire Channel Have a suggestion for a mounting clip? Don't be afraid to contact us on our Facebook page, or send us a message here! www.facebook.com/siskfamilylightshows Like my designs? Help support us by donating to our show! Thanks for looking at and supporting my designs!