20x20 45 degree FC FPV Flight Controller adapter BetaFPV Twig

thingiverse

AIO FCs are too weak, when one died on my BetaFPV Twig, i decided to put a 20x20 stack since the Twig's frame has the holes and support for it, the only problem is that they're set in 45 degree angle from the front. So I started tinkering with a simple solution with tinkercad. Used two 20x20 squares, 1mm height didn't cut it, too thing. went to 2mm and one 1.5mmX3mm to keep it low, depending on your frame any could work for you. on the Twig the bottom battery strap is 15mm, I made it hallow and left it open so the adapter can screw flush with the frame to keep the stack low profile, for my Twig frame mamba ESC and 3 O rings I used: 45 20x20 FC standoffs 15mm strap space in middle - perfect for Twig.stl fits perfectly. i uploaded all the others I tried incase they fit other frames. I Made them all with no support, if you have a good leveled bed and good printer I didn't use adhesion or a raft. I used 100% infill for most durability for the adapter and so it lasts as long as possible without having to replace it, but u can use less.