20x20 v-Slot Corner Joint

thingiverse

I wanted to build a 4 post rack for small components using left over 20mmx20mm v-slot railing. I designed this to allow me to do so. Each rail should be able to be "locked" in place with at least 2 screws and I also recessed the screw holes so they should be flush with the corner joint surface. The screw holes are designed for the circular 10mm screws. Print Settings Printer Brand: Robo 3D Printer: R1 ABS + PLA Model Rafts: Doesn't Matter Supports: Yes Infill: 30 Notes: This should fit on a smaller print bed (5x5x5 for example, ive used my xyz da vinci jr for example). I printed with a pretty thick infill to give support and also supports to allow top components to bridge successfully. I would also recommend lined based supports (not waffle) as waffle was a pain to clean up with the tolerance for the rail to slide in.